Stm32 ihex vs hex12/11/2023 ↳ Let us know a bit about you and your projects. Then for boards, there are many with different stm32 chips and that extends further to 3d printer boards a lot of them use stm32 among the offereings. It would be much easier to switch between different microcontrollers in the family. STM32 is a large family of microcontrollers. These boards and chips are recommended because they have lots of sram and flash, and stm32f405 is fast, so that you won't need to worry about it mostly while getting started learning the mcu platform. the stm32f401 / f411 'blackpill' type boards. Which is also used in the micropython board Then Adafruit has a board with much faster chip stm32f405 and some vendors substitute 'clone' chips on the boards stm32f103c6 (only 32k flash) rather than the correct stm32f103c8 (64k flash) or better stm32f103cb (128k flash) chips. then for the boards, check the chips, some vendors substitute different chips e.g. Then not least, there are 'clone' stm32f103 'like' chips which may not be made by ST, make sure you are using an original STM32 if you are after all using the original stm32 tools. There are some other cores / copies of the codes scattered around the internet which are likely forks of these original or that they may be different implementations. There is an 'old' (Libmaple) community core here and the wiki in the repository Note that the 'official' stm core is here If the programming succeeds but that the sketch didn't work, that is a different issue Stm32f103xx needs to use that st-link dongle or a usb-uart dongle to program it. Did you use that st-link dongle as like discussed?
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |